Mixer1

Created Wednesday 06 August 2014

A stationary model of a mixer computing the mass specific enthalpy and mass flow rate at the outlet.

1. Purpose of Model


The model is supposed to be used for the simplified simulation of static cases. Its main purpose is to provide appropriate start or nominal values for similar dynamic model versions.

It computes the stationary values of:

2. Level of Detail, Physical Effects Considered and Physical Insight


2.1 Level of Detail


Referring to Brunnemann et al. [1], this model refers to the level of detail L1 because the model only computes a set of parameters stationary in time for the given conditions.

2.2 Physical Effects Considered


3. Limits of Validity


For details see SteamSignal_blue, SteamSignal_red and SteamSignal_green.

4. Interfaces


4.1 Steam Signals


For details see SteamSignals.

Inlet1: Blue connector
Inlet2: Blue connector
Outlet: Blue connector

4.2 Medium Models


VLE medium model

5. Nomenclature


6. Governing Equations


6.1 Governing Model Equations

The signal directions at the connectors of the mixer is illustrated below:

Energy


The mass specific enthalpy at the second outlet port is given by

Pressure


The pressures at the inlet ports are set equal to the pressure at the outlet port

Mass


The stationary The mass flow rate at the outlet port is computed by

Summary

A summary is available including the following:

7. Remarks for Usage


The model can only be connected with components with matching connector

colour

(see Example of Usage in StaticCycles).

9. References

[1] Johannes Brunnemann and Friedrich Gottelt, Kai Wellner, Ala Renz, André Thüring, Volker Röder, Christoph Hasenbein, Christian Schulze, Gerhard Schmitz, Jörg Eiden: "Status of ClaRaCCS: Modelling and Simulation of Coal-Fired Power Plants with CO2 capture", 9th Modelica Conference, Munich, Germany, 2012

10. Authorship and Copyright Statement for original (initial) Contribution

Author:
DYNCAP/DYNSTART development team, Copyright 2011 - 2022.
Remarks:
This component was developed during DYNCAP/DYNSTART projects.
Acknowledgements:
ClaRa originated from the collaborative research projects DYNCAP and DYNSTART. Both research projects were supported by the German Federal Ministry for Economic Affairs and Energy (FKZ 03ET2009 and FKZ 03ET7060).
CLA:
The author(s) have agreed to ClaRa CLA, version 1.0. See https://claralib.com/pdf/CLA.pdf
By agreeing to ClaRa CLA, version 1.0 the author has granted the ClaRa development team a permanent right to use and modify his initial contribution as well as to publish it or its modified versions under the 3-clause BSD License.

11. Version History

04.08.2014 - Version 1.0.0 - Timo Tumforde, XRG Simulation GmbH
12.06.2016 - Version 1.1.1 - updated connector positions to be compliant with StaCy's general connector rules- Friedrich Gottelt, XRG Simulation GmbH
06.06.2017 - Version 1.2.2 - Added summary, Timm Hoppe XRG Simulation GmbH


Backlinks: ClaRa:StaticCycles